Tie One End Of The Cord Into A Basic Single Knot About Three To Four Inches From The Tip Of The Other End Of Cord.
Now take the loop and tape or clip it to a flat surface , such as a clip. Cut your cord to the desired length. Lay the knot cord alongside the bracelet cords, keeping them all straight and not crossing over each other.
Hold The Loop In Place With Your Index Finger And.
Fold two pieces of cord of length 18 inches or so by the middle and keep the folded cords facing each other as in the. Using fine beading stretch cord elastic doubled for strength, you will learn how to. Take the two cords/ strings that you chose , fold them in half , and tie a overhand knot , which you'll now have a loop.
Here's How To Tie A Simple Sliding Knot For Any Polyester, Velvet, Leather Or String Type Necklace Or Bracelet.
To get started, lay the knot cord on top of the base cord. It looks neat and stylish, is a very practical closure, and is very easy to make. Securing your bracelet by yourself;
Measure Your Desired Bracelet Or Necklace Length And.
Start wrapping the long end of the knot cord around the three other cords. Pull the cord ends until you have. Now pass the end in your left hand over and under the end in your right hand.
Tie The Remaining Loose End Around The First String.
Using no glue, this professional and easy technique is perfect to learn how to make beaded elastic bracelets. Join jewelry expert extraordinaire tegan as she goes through the proper steps on how to tie and secure a stretch cord bracelet knot!if you found this tutoria. Make sure that not too much excess cord sticks out of the knot.
